DAX activation for transmit

  • 1
  • Idea
  • Updated 4 years ago
Just upgraded SSDR to 1.3.8. All seemed well, but the rig would key and no power would be produced from my data programs. Much head-scratching and swearing later, it turned out the DAX button in the transmit panel (P/CW tab) had become deselected. I don't know if that happened during the upgrade as I never (knowingly) turn it off.

Maybe another senior moment? Just posting this here in case it helps somebody.
Photo of DrTeeth

DrTeeth

  • 1687 Posts
  • 387 Reply Likes
  • relieved

Posted 4 years ago

  • 1
Photo of Bill-W9OL

Bill-W9OL

  • 726 Posts
  • 56 Reply Likes
I had the same problem about a week ago.
It's not obvious when you need screen real estate and have part of the DAX Control Panel covered.
Photo of Ray Andrews, K9DUR

Ray Andrews, K9DUR, Elmer

  • 238 Posts
  • 61 Reply Likes

I routinely saw this issue with v1.3.0.  I normally leave my 6700 on 24/7.  Often in the morning when I go to check into the  Indiana Digital Traffic Net , I will have no output.  Problem is always that TX on DAX1 has become deselected.

73, Ray, K9DUR