Attempted to setup DSTAR simplex mode today but it acts like the ThumbDV dongle isn't working correctly. Followed the directions precisely according to the D-Star How To Guide. The fellow on the other end saw my Call Sign one time out of many attempts but never any audio. His panadapter (and mine) showed a short burst of the expected TX pattern followed by a narrow carrier signal at the center frequency during PTT. When He Transmits I occasionally see his Call Sign come through and a reasonable looking panadapter and waterfall presentation but no audio. We both tested with and without amplifiers and in normal sideband, audio and signal strength was very good . I stuck the Thumb DV into my PC and it loaded drivers and said the ThumbDV was ready to use. Put it back in my 6500 and same as before. Used software versions 126.96.36.199 and 1.10.15 Beta with same results. Power cycled, uninstalled and reinstalled waveforms with no change. I also have a 6300 which I'm about to try but the 6500 is D-Star challenged. Has anyone seen anything like this?
If you tried to revert back to 1.9.13 SSDR software did you also uninstall the latest D-STAR Waveform and revert back to the earlier D-STAR Waveform program? Maybe Flex can confirm this but I believe the latest D-STAR waveform is only compatible with the Beta SSDR software?
We switched to FreeDV waveform and decode was about 95 to 99%. It's just structure of the codec between FreeDV and Dstar. There not much you do about Dstar as it was developed a long time ago and requires a very solid unwavering signal do to the pour error correction built in the codec.