Crash when changing Profiles work around

  • 2
  • Problem
  • Updated 5 years ago
  • Solved
As many had reported the radio will lose communications when changing profiles and crash which requires a restart of the radio I have had to power cycle the radio a couple of times. 

As a workaround I found that if I close all the pan-adapters (X in the upper right corner of each pan-adapter) and start with a blank screen (Gray Box) then load the profile I have far fewer crashes.   I currently have 17 profiles most of which have 4 pan-adapters some in the ham bands and some for short wave or utility listening... Marine, Aviation, NASA Test Range etc... I cycled through all of these with out clearing and crashed 90% of the time I went through them twice by exiting all the pan-adapters and then calling the profile and only had 1 failure.  

This is with a 6500 if others would test this it may be away to avoid the crashes. I think I saw reports from all 6000 radios except the 6700R 

I wasn't sure were to post this as it's not a Question, Idea, Praise or Problem but the workaround was developed from a problem so I posted it there.

Dan --- KC4GO
Photo of Dan -- KC4GO

Dan -- KC4GO

  • 341 Posts
  • 70 Reply Likes

Posted 5 years ago

  • 2
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9271 Posts
  • 3596 Reply Likes
Official Response
This issue has been addressed in the upcoming SmartSDR v1.4.