Cluster and SDR-Bridge V3

  • 1
  • Question
  • Updated 6 months ago
What address does one put in the SDR-Bridge V3 to get cluster spots into the SmartSDR V3 ?
Photo of William Osborne

William Osborne

  • 40 Posts
  • 4 Reply Likes

Posted 6 months ago

  • 1
Photo of Ed - W2RF

Ed - W2RF

  • 258 Posts
  • 77 Reply Likes
Here are recommended steps for setting up Internet SPOT support with SDR-Bridge V3:

Install a DX cluster client. For example, CC User available at http://www.bcdxc.org/ve7cc/

Configure CC User (or equivalent) to receive desired spots and relay them to a localhost port. In CC User, Port Setup screen, check Enable Telnet and set the Custom Port to 23 (or your choice).

In SDR-Bridge, connect to a Station.
On the Spots tab, Internet Source, set: Host localhost, Port 23 (or your choice).
Click Enable.

In CC User (or equivalent) click Connect and verify that a packet cluster is connected.
Click GET ALL.

Spots should now appear in SmartSDR V3 panadapters.

73 Ed W2RF