Changing RX antenna in one slice changes RX antenna in second slice on 6300

  • 1
  • Problem
  • Updated 1 year ago
  • Not a Problem
Thanks to the generous help of NM1W, I am beginning to learn how to use two slices at once to get the most out of my 6300.  I have two different antennas attached to the rear of my radio.  The hex, of course, is 20m-6m and my vertical is 80 - 10.  I set the slices up for two different bands -- say 17m and 20m digital.  The slice on 17m must remain on the hex as my vertical doesn't have a 17m resonator.  If I set the other slice to 20m on the vertical, the TX stays on the antenna I assigned.  However, when I set the RX antenna on the other slice, both slices show the same RX antenna selection.  How do I keep the RX choices locked?
Photo of Andrew Thall

Andrew Thall

  • 149 Posts
  • 15 Reply Likes

Posted 1 year ago

  • 1
Photo of Bill -VA3WTB

Bill -VA3WTB

  • 3022 Posts
  • 668 Reply Likes
You have one SCU in your radio, so it will only work with one antenna at a time. I have only one in my 6500 as well,,that is how it works, With 2 SCU such as the 6700 and the up coming 6600 you can have both going at one.
(Edited)
Photo of Andrew Thall

Andrew Thall

  • 149 Posts
  • 15 Reply Likes
Thanks for the explanation.
Andy k2oo

This conversation is no longer open for comments or replies.