I installed SmartSDR 1.11.12 today after uninstalling the 1.10 beta. When installed. 1.11 had lost the previous CAT setup information, and the four ports I had created were all shown as "COM73" and unable to be changed to the lower numbers they had been previously. This really screwed up my OmniRig link to Log4OM because I can't specify a COM port over 20 there, and attempting to create a new com port in CAT starts with the lowest number of 73. Am I missing something? I've deleted all the com ports and added them back, but it always starts at COM73 and will not allow selecting anything lower. Any pointers would be welcome.