Can someone tell me how get the power back in the A Flag running SmartSDR?

  • 1
  • Question
  • Updated 5 months ago
Photo of Don

Don

  • 10 Posts
  • 0 Reply Likes

Posted 5 months ago

  • 1
Photo of Clay N9IO

Clay N9IO

  • 529 Posts
  • 123 Reply Likes
Don,
If you're asking about the power meter in the flag just keep tapping it with your mouse, it will cycle through different scale functions.
On the Maestro just tap with your finger same way.
Hope that's what you're looking for.
Photo of Craig - KØCF

Craig - KØCF

  • 146 Posts
  • 48 Reply Likes
Not sure what you are asking... Do you want to enable transmit from Flag A? If that's it, click on the "TX" box right next to the "A" flag indicator.
Photo of Steven Linley

Steven Linley

  • 242 Posts
  • 27 Reply Likes
Time to review the Tutorial. I am still glad it pops up with every boot SmartSDR
Photo of Don

Don

  • 10 Posts
  • 0 Reply Likes
I am running Smartsdr. The A flag is active. There is no power meter in the A Flag. The controls are  active on the right side of the screen. The power meter is at the top of the controls window. It was also in the A Flag but it has disappeared. The only meter in the A Flag is the S meter. I am sure I saw how to do that in the guide but can't  find it.
Photo of k0eoo

k0eoo

  • 602 Posts
  • 81 Reply Likes
Hi Don, there is no power meter on the flag.  the only power meter is over on the right at the top as you already mentioned.  The only meter on the flag is the S-meter so you are good to go....To enable the A flag to transmit all you do is click on the big TX on the flag, it'll turn RED when its enabled.  then you can start sending....

Dennis, k0eoo
(Edited)