can i use a 75amp. switching power supply on my 6300

  • 1
  • Question
  • Updated 2 years ago
75amp. switching power supply from
Photo of john kossuth

john kossuth

  • 7 Posts
  • 0 Reply Likes

Posted 2 years ago

  • 1
Photo of Wayne


  • 614 Posts
  • 89 Reply Likes
Why not? It will only draw as many amps as it needs.
Photo of Ross Lambert

Ross Lambert

  • 15 Posts
  • 3 Reply Likes
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9286 Posts
  • 3601 Reply Likes
Yes, but use caution.  If there is a short of some type, a 75 amp p/s can do a lot more damage than a 30 amp supply.  With high amperage supplies, I recommend using an in-line fast blow fuse to protect the equipment in the event of a fault.
Photo of Ken Hansen

Ken Hansen

  • 352 Posts
  • 114 Reply Likes
As everyone else said, certainly, but I'm curious/concerned about acoustic noise - it's a high-power power supply in a very small package.
Photo of Ken - NM9P

Ken - NM9P

  • 4241 Posts
  • 1355 Reply Likes
The advantage with using a big supply is that you can power multiple pieces of equipment from it.

But as Tim said, absolutely you must use a proper fuse in line.  (Why would anyone NOT fuse their power leads?)

Also....With a switching power supply, I would also be careful about RF trash generated by the switching circuit in the supply itself.

I use an Alinco DM-330MV switching supply, and it is very quiet at my location.  I detect not a hint of RFI above about 400 KHz.  so I just won't operate 2200 Meters.....

There are other switchers that are not as clean.  When you get it, check to see if it generates spurs or hash.  If so...take it back.  What good is it to have a HUGE power supply if the hash it generates raises your noise floor by 10 dB?

Ken - NM9P
Photo of Jim Gilliam

Jim Gilliam

  • 959 Posts
  • 233 Reply Likes

The first thing I did on my two 6500's, is to add in-line fuses (both plus and minus) on the Anderson power cord. Most mfgs. have in-line fuses included with the power cord.

Jim, K6QE

Photo of Bill -VA3WTB

Bill -VA3WTB

  • 4260 Posts
  • 1022 Reply Likes
Seems clear,,everyone agrees with
Photo of George Molnar, KF2T

George Molnar, KF2T, Elmer

  • 1690 Posts
  • 625 Reply Likes
We love our Mayor!
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9286 Posts
  • 3601 Reply Likes
And the Mayor loves all you guys and gals too!  Remember to vote in November!
Photo of Paul - K6HR

Paul - K6HR

  • 140 Posts
  • 27 Reply Likes
I'll vote right now! Give 'em a raise!