B receiver keeps switching to DIGIU

  • 1
  • Question
  • Updated 9 months ago
  • Answered
  • (Edited)
On my 6700 I run three receivers...A,B,C ON FT8 I set all three to USB and set the DAX to 1,2,3 When the B receiver goes to TX is switches to DIGIU and 1 kc width...no matter how many times or no matter what band I use, it switched to DIGIU 1kc... where is it getting this setting or how do I change it??
Photo of AH0U

AH0U

  • 261 Posts
  • 32 Reply Likes

Posted 9 months ago

  • 1
Photo of Craig - KØCF

Craig - KØCF

  • 146 Posts
  • 48 Reply Likes
In WSJT-X in the Settings dialog, Radio tab look at the "Mode" box. If you set it to "None", it will leave the mode setting in the radio alone.

73,
Craig, KØCF
Photo of AH0U

AH0U

  • 261 Posts
  • 32 Reply Likes
Tnx... that was it

This conversation is no longer open for comments or replies.