Welcome to the new FlexRadio Community! Please review the new Community Rules and other important new Community information on the Message Board.
If you are having a problem, please refer to the product documentation or check the Help Center for known solutions.
Need technical support from FlexRadio? It's as simple as Creating a HelpDesk ticket.

ATU failing to tune up 60 meters.

Ronald Barber
Ronald Barber Member
edited January 2018 in FLEX-6000 Signature Series
I have been working FT8 on 60 meters with a DX160 OCF Windom antenna and 60 meters was working just fine.
I worked the NAQP SSB with a DX80 over the weekend because it is higher in the air than the DX160.
When I went back to the DX160 to work FT8 the ATU will not tune 60 meters and the SWR is off the chart.
I have tried a hard reset on my Flex 6300 but it will not tune the antenna at all, it just quickly flips on and off.
Any suggestions?

Answers

  • Bill W2PKY
    Bill W2PKY Member ✭✭
    edited January 2018
    Try this: Right click on the ATU button and left click "erase ATU memories"
  • Tim - W4TME
    Tim - W4TME Administrator, FlexRadio Employee admin
    edited January 2018
    Here is the issue.  In USB mode, the TUNE carrier is on the suppressed carrier frequency (what is displayed in the slice frequency readout).  60m is a channelized band, so that frequency is technically always a band edge.  If you do a TUNE operation on that frequency, some of the RF emissions are outside of the channel (out of band).

    You need to change to CW to do a TUNE operation or tune up in frequency about 100 Hz and it will work.
  • Ronald Barber
    Ronald Barber Member
    edited January 2018
    Thank you both.
    It worked perfectly and now I am on my way to finishing my WAS on 60 meters.
    Only 26 confirmed more to go!
    Ron--W4CHI.

Leave a Comment

Rich Text Editor. To edit a paragraph's style, hit tab to get to the paragraph menu. From there you will be able to pick one style. Nothing defaults to paragraph. An inline formatting menu will show up when you select text. Hit tab to get into that menu. Some elements, such as rich link embeds, images, loading indicators, and error messages may get inserted into the editor. You may navigate to these using the arrow keys inside of the editor and delete them with the delete or backspace key.