Anyone else notice their 6XXX not changing bands ?

  • 2
  • Question
  • Updated 3 years ago
  • Answered

Wondering if anyone else noticed this. Four times
now, I have chose a frequency from memory and then
went to another band after operating a while. I
first went to 80 meters with the memory button. The
radio was 80 meters for about 5 hours. Then I used
the band button to go from 80 to 160. The screen
shows I am on 160 but the radio stayed on 80. Then
if I choose the band from memory, then it will go to
the correct band.
Example I was then on 160 listening to Newsline on
1860 AM, went to the gen band by the button to 900
KHz, then pressed the 80 meter button. Everything
changed and could see CW signals around 3555 KHz.
But the audio from 160 was coming through.
But this does not happen every time. So not sure if
I should reload the software or others have noticed
this also.
Version is

73, Jim N9VC
Photo of N9VC


  • 191 Posts
  • 58 Reply Likes

Posted 3 years ago

  • 2
Photo of Mark - W3II

Mark - W3II

  • 237 Posts
  • 53 Reply Likes
Official Response
A defect report on this issue has been logged by FRS Engineering.