All SDR CAT ports show error

  • 1
  • Question
  • Updated 3 years ago
  • Answered
The SDR CAT Com port list under V1.6 shows COM ports 4,5,6 and 7 have been created.  However, the red Error message appears on all ports.  When I hover over the error message for COM4, it says "has COM14 open which is needed by this port".  Could someone interpret the error message and what I need to do to eliminate it.  I have nothing connected to these ports at present.

Thanks, Bob, KN4HH
Photo of Bob  KN4HH

Bob KN4HH

  • 91 Posts
  • 21 Reply Likes

Posted 3 years ago

  • 1
Photo of Bob  KN4HH

Bob KN4HH

  • 91 Posts
  • 21 Reply Likes
Official Response
Thanks, guys.  It was a combination of problems starting with old defined ports and old VSP driver.  All is well now.  I really appreciate all the helpful comments.

73, Bob, KN4HH