Adjusting sliders in DAX

  • 1
  • Question
  • Updated 10 months ago
Only had my 6400 a week and still learning, I have fl digi working, I was used to adjusting alc on 590 but wonder if I have too much or maybe too little using Dax. See in instructions that sliders should be less than 0, so as close to 0 is ok? Also on audio to fl digi have sliders all way over too right and don’t see the typical blue waterfall in fl digi, see signals, trying to make sure I have alc and audio to program set right, thanks for reading and any input.
Photo of KI4P

KI4P

  • 142 Posts
  • 31 Reply Likes

Posted 10 months ago

  • 1
Photo of Keith Flint

Keith Flint

  • 56 Posts
  • 3 Reply Likes
Try clicking with mouse pointer just to the left of the dot slider to go down one point or just to the right of the dot slider to go up one point. It works nicely to micro adjust any slider,
Keith
W7ZAC
Photo of KI4P

KI4P

  • 142 Posts
  • 31 Reply Likes
Thank you Keith
I guess my main concern is greeting to much on tx audio, and understanding the sliders
Photo of Larry - W8LLL

Larry - W8LLL

  • 532 Posts
  • 116 Reply Likes
Read this post, it should give you the info your looking for.

https://community.flexradio.com/flexradio/topics/ft8-and-alc-on-6500
Photo of KI4P

KI4P

  • 142 Posts
  • 31 Reply Likes
Thanks helped tremendously!