adjustable band width does not work correctly

  • 1
  • Problem
  • Updated 5 years ago
  • Solved
On adjusting the high cut/low cut say to 50/3250 it will work . now turn off the radio turn it on and the transmit filter bandwidth will display 50/3250.
However the transmit bandwidth is not correct . it is not 50/3250 as displayed

it is necessary to highlight the low cut/high cut enter a different transmit filter setting and it will then go to this setting.
Yes it will then display this new setting . However the same thing will happen again when you turn it off . When you turn it back on it will display what you set last but this again is not correct . And necessitate you to re enter another filter band width to have it work at that band width.
.
Photo of Ed baker

Ed baker

  • 114 Posts
  • 8 Reply Likes

Posted 5 years ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 8684 Posts
  • 3262 Reply Likes
Official Response
This is a defect in the software. It has been addressed in the next release of SmartSDR for Windows (> 1.0.0).