6700 TX on ant1 or ant2 and SCU confusion!

  • 1
  • Problem
  • Updated 5 years ago
  • In Progress

I have a 6700 and just recently attached a 2nd antenna to the Ant2 connector.   I fired up the 6700, opened two panadapters, created a single slice receiver on each panadapter, on the first panadapter I set the band to 40 meters and assigned RX ANT1 / TX ANT1. On the 2nd panadapter I set the band to 20 meters and assigned RX ANT2 / TX ANT2.

So far so good.  The problem comes when I click on TX on the 20meter or 40 meter panadpater, the TX ANT keeps changing to the last one used.  In other words, If I'm on 40 meters using RX ANT1 / TX ANT1, then click on the TX button on the 20 meter panadapter, the TX ANT2 changes to TX ANT1.

This doesn't seem right and I'm sure I'm missing something here.  Any words of wisdom?

Photo of Norm S

Norm S

  • 64 Posts
  • 3 Reply Likes

Posted 5 years ago

  • 1
Photo of Tim - W4TME

Tim - W4TME, Customer Experience Manager

  • 9152 Posts
  • 3478 Reply Likes
Official Response
This defect has been previously reported and it is in the bug tracker.  It is slated to be addressed in SmartSDR v1.3