6500 and 6700 operate only with mark freq 2125 on RTTY WHY

  • 1
  • Question
  • Updated 3 years ago
  • Answered
I posted a question about having a problem with the 6500 and 6700 not tuning on RTTY.
I have now narrowed the problem down to the radios will not allow tuning unless the mark freq. is above 1950hz. below that Freq the tune button on SSDR does not operate the transmission.
So why dis this happening as I would like to operate 2 Tone at 1275hz.
It is a problem that has just appeared, and probably after I updated to 1.8.4

Regards
Ross
ZL1WN/ZL1N
Photo of Ross Biggar

Ross Biggar

  • 129 Posts
  • 2 Reply Likes

Posted 3 years ago

  • 1
Photo of k3Tim

k3Tim

  • 865 Posts
  • 170 Reply Likes
Official Response
I have mine set at 1.0Kc. I did have to make sure the Xmit cutoff frequency on the PNHE passed these tones.  You had a B-0-0-M-I-N-G signal into So. CA at 05:30 UTC -20 Aug but I couldn't seem make it.

k3Tim/6
Photo of Dudley - WA5QPZ

Dudley - WA5QPZ

  • 212 Posts
  • 45 Reply Likes
Official Response
Ross, 

Change you low cut TX filter edge ..   Dudley