6400M Skipping the software selection and booting to operation

  • 1
  • Problem
  • Updated 3 months ago
  • Not a Problem
Since the last software and firmware update my 6400M is skipping the software selection on each boot up.  So Tim it has not been fixed.  In fact it wasn't a problem before the update but it is a problem now.
Photo of Ron WD5FUN

Ron WD5FUN

  • 25 Posts
  • 6 Reply Likes

Posted 3 months ago

  • 1
Photo of Ronald / W4RJF

Ronald / W4RJF

  • 23 Posts
  • 1 Reply Like
Photo of Ron WD5FUN

Ron WD5FUN

  • 25 Posts
  • 6 Reply Likes
Thanks Ron, I have read that reply from Tim, but I have upgraded to 2.2.8 and that is when the problem started.  So 2.2.8 is causing the problem not fixing it.
Photo of Barry Simpson

Barry Simpson

  • 18 Posts
  • 0 Reply Likes
Ron

I am not sure what you are considering is the problem. The modus operandi with the new software update is that the rig now boots up directly into operational mode. If you want to regress to an earlier version, you do that via Menu/Radio.

73

Barry  VK2BJ
Photo of Ron WD5FUN

Ron WD5FUN

  • 25 Posts
  • 6 Reply Likes
OK Barry thanks, I reread the change is to 2.2.8 I and see the radio was not suppose to show the version screen.  Since it always did go to the selection screen I thought that was what it was suppose to do.  Sorry for my misunderstanding.
(Edited)

This conversation is no longer open for comments or replies.