6300 v1.3 not keying amp

  • 1
  • Problem
  • Updated 4 years ago
  • Solved
After upgrading to v1.3 the 6300 stopped keying the amp (RCA connector).

I have enabled "RCA TX1" in the setup.

73, Andreas, N6NU 
Photo of Andreas Junge

Andreas Junge, Elmer

  • 37 Posts
  • 3 Reply Likes

Posted 4 years ago

  • 1
Photo of Jim K4JAF

Jim K4JAF

  • 304 Posts
  • 74 Reply Likes
Check that you have the Amp plugged into the correct RCA on the back of the 6300.  Very easy error to make.  73s Jim K4JAF
Photo of Andreas Junge

Andreas Junge, Elmer

  • 37 Posts
  • 3 Reply Likes
It worked with the previous version. I have not touched the cable. 
Photo of Steve N4LQ

Steve N4LQ

  • 568 Posts
  • 92 Reply Likes
Did you reboot the 6300?
Photo of Andreas Junge

Andreas Junge, Elmer

  • 37 Posts
  • 3 Reply Likes
Yes. After the installation of 1.3. I also turned it off a few times when not using the radio. Maybe I'll try to unplug the power cable. 
Photo of Steve N4LQ

Steve N4LQ

  • 568 Posts
  • 92 Reply Likes
Are you otherwise transmitting cw ok? Had to ask.
Photo of Andreas Junge

Andreas Junge, Elmer

  • 37 Posts
  • 3 Reply Likes
Yes. 
Photo of Andreas Junge

Andreas Junge, Elmer

  • 37 Posts
  • 3 Reply Likes
OK - I pulled the power all the way. Now it's keying ...

Thanks for all the input. 

73, Andreas, N6NU
(Edited)

This conversation is no longer open for comments or replies.