6300 Auto On on 12v possible?

  • 1
  • Question
  • Updated 5 years ago
  • Answered
Operating Remote on LAN, (VNC) .. have westmountian rigrunner on local lan and can remote power on my 6300.  Any way to configure the 6300 to boot on power?  
Photo of Steve B.

Steve B.

  • 13 Posts
  • 4 Reply Likes

Posted 5 years ago

  • 1
Photo of Nick - W2NER

Nick - W2NER

  • 92 Posts
  • 23 Reply Likes
I would like to know that too so I can power up and power down the 6500 from the power supply.  I thought I read someplace that doing this was a bad idea.  Can anyone confirm this?
Photo of KY6LA - Howard

KY6LA - Howard, Elmer

  • 3763 Posts
  • 1621 Reply Likes
Official Response
There is a detailed discussion on remote power on/off at


https://community.flexradio.com/flexr...


I run my 6700 remotely virtually 90% of the time


I use a WEMO switch to control power to a 12v relay connected across the remote. Power terminal on my 6700.


My 12V power bus is powered all the time

"The remote on/off works by using the RCA remote-on connector on the back of the radio. Latch the line to ground and the radio will power up, remove ground and the radio will power down. Note that this is a open-collector input so you will need a pull-up resistor or a source that provides a positive voltage on its own."
(Edited)
Photo of Gerald - K5SDR

Gerald - K5SDR, Employee

  • 830 Posts
  • 1514 Reply Likes
Note that the Remote On input has its own pull up to 3.3V so you do not need an external pull up.  Just provide a relay contact closure or a transistor/FET drive to ground.
Photo of Steve B.

Steve B.

  • 13 Posts
  • 4 Reply Likes
Thanks All .. I have tied this my webpower witch .. it has reply outs .. if anyone is interested .. here's what I use for remote 110v switching .. works great   http://www.digital-loggers.com/lpc7.html

This conversation is no longer open for comments or replies.