I've been looking to 60 mts...
IARU 2 , 2017 Band Plan
60 METERS Frequencies (kHz) BW (Hz) Mode Applications and observations 5351.5 - 5354 500 CW, DM 5354 - 5366 2700 All Modes 5366 – 5366.5 20 CW, DM ACDS
Why my flex doesnt TX?
Thank you
George
YV5WZ / PY3ZZZ
IARU 2 , 2017 Band Plan
60 METERS Frequencies (kHz) BW (Hz) Mode Applications and observations 5351.5 - 5354 500 CW, DM 5354 - 5366 2700 All Modes 5366 – 5366.5 20 CW, DM ACDS
Why my flex doesnt TX?
Thank you
George
YV5WZ / PY3ZZZ
- 415 Posts
- 50 Reply Likes
Posted 2 years ago
Ria - N2RJ, Elmer
- 2276 Posts
- 918 Reply Likes
I am guessing that if your radio has a USA TURF file that it is programmed to comply with FCC rules. Basically it will only allow transmission in the dead center of the channel per FCC ruling and if you have WSJTX set to "fake it" then it will think the radio is out of band and then tx inhibit.
Alex - DH2ID, Elmer
- 955 Posts
- 177 Reply Likes
George, what does your Region show under the Settings-Radio Setup-Radio tab?
I know that IARU region 2 rules apply for your country, but for the 60m band local
allocations and rules apply and vary widely.
I know that IARU region 2 rules apply for your country, but for the 60m band local
allocations and rules apply and vary widely.
- 415 Posts
- 50 Reply Likes
Hey !! Alex
My Flex follows USA rules.....USA Turf
Best Regards
73's
George
My Flex follows USA rules.....USA Turf
Best Regards
73's
George
- 300 Posts
- 61 Reply Likes
Another tip - be sure your Tx bandwidth is not set too high. It should be no more than about 2.8 kHz -- normal SSB setting. Otherwise Flex thinks you are going to Tx outside the (narrow) allocated band. But it all depends on your national rules -- and what Flex has coded in its "TURF" limits. See https://community.flexradio.com/flexradio/topics/what_is_a_turf_file .
(Edited)
- 415 Posts
- 50 Reply Likes
Thanks Martin
I will check ....usually I have 5.0 Khz and DIGU
Best Regards
George
I will check ....usually I have 5.0 Khz and DIGU
Best Regards
George
Tim - W4TME, Customer Experience Manager
- 9153 Posts
- 3497 Reply Likes
US 60m channels are only 2.8 kHz wide. I suspect you are transmitting outside of the channel bandwidth.
Related Categories
-
FLEX-6700 Signature Series SDR
- 2852 Conversations
- 592 Followers
-
FLEX-6500 Signature Series SDR
- 3386 Conversations
- 876 Followers
-
FLEX-6300 Signature Series SDR
- 2778 Conversations
- 801 Followers
YV5WZ
WSJT-X set to "None"
73's
George
YV5WZ / PY3ZZZ