Conversations

Conversations 1 - 20 of 192
Photo of Wayne
WWV shutdown annonunced
So WWV is ending service but a feature of the new rigs and firmware/software is accurate freq calibration. So is flex going to provide an...
  • 1 me too
  • 19 replies
  • Question
Photo of David Decoons wo2x
Customize RX filters (right click & configure)
Hi All,I was talking to the guys from Flex this weekend at the ARRL Centennial convention the subject was brought up about future ability...
  • 39 me toos
  • 27 replies
  • Idea
Photo of mikeatthebeach .
SDR Ios App Antenna Rotor Needed using iPhone 8+ Any Idea's Anyone
Looking for an SDR Ios App Antenna Rotor Needed for use on a Apple iPhone  8+ Any Idea's Anyone Now using The FlexRadio SDR iOS from Mark...
  • 3 me toos
  • 7 replies
  • Question
Photo of paul
MAESTRO hotel access
Cannot connect to 6300 from hotel, Maestro says I am connected to wifi but unable to   to enter hotel security code to connect to 6300 at...
  • 1 me too
  • 5 replies
  • Problem
Photo of John - K3MA
Power Genius XL Amplifier Noise
Below I have copied with permission some information on the cooling of the RF-Kit 2K+ amplifier.  It uses a pair of LDmos finals and prod...
  • 1 me too
  • 13 replies
  • Question
Photo of Mark Griffin
IC-7300 Receiver Front End Overload
I was reading a review last evening on Eham and took note regarding a post regarding the IC-7300 Front End Receiver Overload that the use...
  • 1 me too
  • 10 replies
  • Question
Photo of John n0snx
Is there any reason the 6000 series radio should not be ran 24/7???
  • 1 me too
  • 7 replies
  • Question
Photo of Clay N9IO
New Shack Picture at N9IO June 2018
The new 6600 is working great! Thought it was time to show a pic of my shack... de Clay N9IO
  • 6 me toos
  • 4 replies
  • Praise
Photo of Richard Clafton W4/G7EIX
Maestro won't power up.... anyone seen this issue before?
So.... I just took my Maestro off the shelf, where it has been for about 6 months without use in my shack. I have tried it on several ba...
  • 3 me toos
  • 29 replies
  • Question
  • Answered
Photo of Richard McClelland, AA5S
KPA1500
http://www.elecraft.com/KPA1500/KPA1500%20FAQ%20rev%20A1b.pdf
  • 2 me toos
  • 14 replies
  • Idea
Photo of Steve - K6SRS
Low RFI wall warts?
I'm slowly working down the noise floor that is bothersome in the lower bands.  I've made some decent progress with robust grounding of a...
  • 2 me toos
  • 9 replies
  • Question
Photo of Bob Wright, N7ZO
CW on SSB modes
With the recent sporadic E openings on 6 meters, I find I miss a feature I had on my K3 which is the ability to transmit CW while in USB...
  • 29 me toos
  • 16 replies
  • Idea
  • Under Consideration
Photo of Ken - NM9P
Bodnar GPS disciplined oscillator
With so much discussion about GPSDO's, and the recent article in QST, I was wondering if the under $300 Bodnar GPS Disciplined Oscillator...
  • 4 me toos
  • 14 replies
  • Question
Photo of Steve K9ZW
6400/6600 - An Opportunity to Upgrade Connectors?
With the New Flex-6400, Flex-6400M, Flex-6600 and Flex-6600M moving from Prototype to Production, is this an opportunity to upgrade the r...
  • 6 me toos
  • 20 replies
  • Idea
  • Not Planned
Photo of Ken - NM9P
Tennadyne T-11 on the way! any advice on using with the 6500?
I just pulled the trigger and ordered a T-11 this morning. It should arrive in a couple of weeks. Now I am looking for tower, rotor, an...
  • 3 me toos
  • 24 replies
  • Question
Photo of N2LRB
SSDR V2.0 IOS Needs Restore Constantly
In using V 2.0 of SmartSDR on IOS, I have found that it asks to be restored about once every two to three times.  I do it and it works. B...
  • 2 me toos
  • 7 replies
  • Problem
  • Solved
Photo of KC2QMA_John
No S-Meter through CAT in 1.6.17
I noticed that after the update I don't seem to be getting S-Meter readings from my 3rd party apps (HRD, Smartmeter) maybe I'm just missi...
  • 3 me toos
  • 10 replies
  • Question
  • Answered
Photo of Greg - KØGDI
Should I sell my Palstar HF-AUTO so I can get Tuner Genius?
I preordered the PowerGenius XL within 3 minutes of it being announced and see it comes with the TunerGenius.  Would it be safe to say th...
  • 1 me too
  • 5 replies
  • Question
  • Answered
Photo of Bill  /  VA3QB
Will SmartSDR 2 be Morse Code Compatible
With the release of smartSDR 2 , will a user on a computer/laptop in remote mode be able to use Morse Code ?  At present it only works di...
  • 1 me too
  • 3 replies
  • Question
  • Answered
Photo of KY6LA - Howard
Single Point of Failure Remote
I have been REMOTING from my son's winery in Northern California this Week. When I went to try SmartSDR for iOS v1.0.2 yesterday I could...
  • 1 me too
  • 34 replies
  • Question