Conversations

Conversations 1 - 20 of 185
Photo of W7NGA
odd filter adjust behavior
I noticed that dragging the 100hz lower-filter limit to the left, sets the value to 0 as expected, but further movement to the left skews...
  • 1 me too
  • 1 reply
  • Problem
Photo of Mark WS7M
Flex 6600 Delivery Pool
Ok I ordered my 6600 on 02/10/18 (a Saturday).  So lets advance that and say that it really makes it into FRS system on Monday: 02/12  (y...
  • 1 me too
  • 6 replies
  • Idea
Photo of Mark - WS7M
6600 plug sizes?
Hi all, I broke down and ordered a 6600 which I know will be quite a few weeks out for delivery.  I think it was the two SCUs and the be...
  • 1 me too
  • 6 replies
  • Question
  • Answered
Photo of Al / NN4ZZ
MaestroControl - the next generation FlexControl
FRS has announced that a version of the Maestro software will eventually be released that will  operate as a control surface and run conc...
  • 14 me toos
  • 13 replies
  • Idea
Photo of Mark - W3II
FRStack Version 2.1.30.4 Released
FRStack has been updated to work with FlexRadio Systems next generation radios.FRStack will work with your 1.X and 2.X based radios.FRSta...
  • 4 me toos
  • 12 replies
  • Praise
Photo of Jim K4JAF
USB Bit Cable usage
Anyone using the USB Bit cable to choose multiple antennas on a band?  IE, say dipole or vertical on 80 meters by specifying frequency ra...
  • 1 me too
  • 2 replies
  • Question
Photo of W7NGA
Preamp gain control not centered ....
Most likely already reported, but my wife walks into the shack and says 'How come the little dot isn't centered in the cradle?'.  I had t...
  • 1 me too
  • 5 replies
  • Problem
Photo of Joe Sartori - K3WTF
Confused on Microphone for 6400
Trying to decide what Mic to get for the new 6400.  I have had good results with the Heil line for my Icoms, but kinda have been looking ...
  • 1 me too
  • 5 replies
  • Question
  • Answered
Photo of Larry - WA7LZO
Maestro Online - In The Bar!
Great reception at the bar, as the joint's WiFi works OK. Oh, and that's a nice snifter of Courvoisier XO cognac my brother Jim, KA7GZR, ...
  • 5 me toos
  • 7 replies
  • Praise
Photo of Bill -VA3WTB
is there squelch in FRstacks?
  • 1 me too
  • 9 replies
  • Question
  • Answered
Photo of Roy Laufer
Any opinions/experience with the RadioSport hand operated PTT
I've written before about how much I value my RadioSport RC-60CF headset. I needed to disassemble and fix the cherry momentary switch in...
  • 1 me too
  • 5 replies
  • Question
  • Answered
Photo of john norris
Don't see RF Power / SWR levels in SDR when transmitting phone
I'm using the Flexradio 6300 for phone operation for the first time .. I had previously used it just for digital modes and is working fin...
  • 1 me too
  • 9 replies
  • Question
  • Answered
Photo of W7NGA
Invisible slice created in v2.0.17
Summary - Out of factory reset, the first attempt to create new panadapter fails. It does create Slice B but there is no associated windo...
  • 1 me too
  • 5 replies
  • Problem
  • Solved
Photo of Ken - NM9P
Tennadyne T-11 on the way! any advice on using with the 6500?
I just pulled the trigger and ordered a T-11 this morning. It should arrive in a couple of weeks. Now I am looking for tower, rotor, an...
  • 3 me toos
  • 24 replies
  • Question
Photo of Mark Griffin
IC-7300 Receiver Front End Overload
I was reading a review last evening on Eham and took note regarding a post regarding the IC-7300 Front End Receiver Overload that the use...
  • 1 me too
  • 10 replies
  • Question
Photo of Barry N1EU
Receive Latency
I just made some measurements on cw receive latency and wanted to share them.  I used a simple methodology of recording the tx sidetone i...
  • 2 me toos
  • 21 replies
  • Idea
Photo of Bob G   W1GLV
How to get band data from a Parallel Port
Does SSDR send band data to the parallel port like PSDR did?
  • 1 me too
  • 7 replies
  • Question
  • Answered
Photo of Paul F6EXV
Flex 6500 and RTTY/PSK
Hello all. Which would be the most appropriate RTTY/PSK decoding program to use in order to take full advantage of the 6500 ? I am not se...
  • 1 me too
  • 13 replies
  • Question
  • Answered
Photo of Jim Shaffer (KE5AL)
extra space when sending
I am using version 1.10.15 on my Flex 6300.  I've noticed that I sometimes get an extra space when sending a string using the cwx facilit...
  • 2 me toos
  • 2 replies
  • Problem
  • Acknowledged
Photo of Moose
Bose Companion Speakers Power Supply Noise
After reading different opinions for speakers on the forum I purchased Bose Companion 2 Series III speakers. They do sound good, but I ge...
  • 2 me toos
  • 5 replies
  • Question
  • Answered