Conversations

Photo of Ron
Change Mode using USB Cable
I am successfully using a USB cable to communicate with an Arduino-based mag loop controller.  The cable passes transmit and frequency co...
  • 1 me too
  • 7 replies
  • Question
Photo of Ron
Too smart for it's own good...
I use slice A to listen for signals and use slice B on the panadapter tied to FLDigi to transmit digital modes.  Every time I 'Move Slice...
  • 2 me toos
  • 8 replies
  • Question
  • Answered
Photo of Ron
Unhandled Exception 1.6.17
Well, everything was working ok for a day or two.  Suddenly I am getting un-handled exception messages a couple of seconds after connecti...
  • 1 me too
  • 4 replies
  • Problem
  • Solved
Photo of Ron
RMS Express SmartSDR Latency
I have RMS Express loaded and communicating with my 6500 and SmartSDR using Winmor 2K.  A dedicated CAT port is configured in Smart CAT. ...
  • 1 me too
  • 3 replies
  • Question
Photo of Ron
6500 Running Multiple Bands
I did a presentation on my Flex 6500 to my local ham club and a question came up.  Since the Flex selects the initial bandpass filter pri...
  • 1 me too
  • 6 replies
  • Question
  • Answered
Photo of Ron
SSDR v1.4 DAX Issue with Fldigi?
I just upgraded to SSDR v1.4 and noticed blank spaces in my FLDigi waterfall (see attached).  I thought the issue might be related to to...
  • 1 me too
  • 6 replies
  • Question
  • Answered
Photo of Ron
Running FLDigi and Log2OM
I seem to have run into an issue when running both FLDigi and the Log2OM logging program. FLDigi seems to require RigCat rig control to b...
  • 1 me too
  • 3 replies
  • Problem