Conversations

Conversations 21 - 32 of 32
Photo of Luis del MOlino
Digital S-meter more visibility
I love the digital S-meter of Flex-1500 because it allows to check changes in noise floor, gain of antennas, very small differencies in s...
  • Luis del MOlino, 4 years ago

  • 2 me toos
  • 0 replies
  • Idea
Photo of KY6LA - Howard
How about Digital SWR meters. And more visible colors
Thanks for digital dBm readings Now please fix Colors on the SWR and S meters so that they are more readable More important, how ...
  • 11 me toos
  • 6 replies
  • Idea
  • Under Consideration
Photo of Asher - K0AU
Single Point Ground
Probably the last one to figure this one out, but I installed a 1" copper bus bar and tied every piece of ham equipment to the bus bar th...
  • 1 me too
  • 17 replies
  • Idea
Photo of darrell montgomery
GPU usage
How can you find out if SSDR is able to use the graphic card or is using the cpu for the graphics displayed. I notice a box on the bottom...
  • 1 me too
  • 11 replies
  • Question
  • Answered
Photo of Bill -VA3WTB
Computer sound with Flex 3000
I am wanting to use my sound card in my Flex computer to use as my audio EQ. How do I make the Flex see it?
  • 1 me too
  • 2 replies
  • Question
Photo of Tony Hateley
swl problem
while operating in digi mode on 28,140,i tune flex 6500 says success with my longwire,but when I send the swl meter goes off scale,anyone...
  • 1 me too
  • 6 replies
  • Problem
Photo of Steve/N6KOG
PTT using DEMI 2MTR XVTR
Unable to get the DEMI two meter transverter to transmit, using any one off the three "TX Relay outputs" RCA connectors #1, #2 or #3 for ...
  • 1 me too
  • 3 replies
  • Problem
Photo of Ken Broome
No audio with Flex 1500
Just loaded SDR 1500 softward to my laptop (W8OS) and get no audio.  Anyone know what my problem might be?  Thanks, Ken
  • 2 me toos
  • 5 replies
  • Question
  • Answered
Photo of Robert Watson
SmartSDR CAT 1.3.8 problem
I have been running SmartSDR 1,3,8 for some time with no problems.  I have been trying to get 3rd party programs (Logger 32, FLDIGI) to c...
  • 1 me too
  • 6 replies
  • Problem
Photo of mike
Anyone using open wire feed line with Flex 5000 or 6000 series
I have been using an EDZ antenna fed with 600 ohm open wire line but have been unsuccessful in stopping 100% of the RF from getting into ...
  • 1 me too
  • 4 replies
  • Question
Photo of Luis del MOlino
Please reverse mouse UP/DOWN movement to change filter width
You have to move the cursor up or down to change the received band width, when you put the mouse by the lower part of the panadapter, jus...
  • 1 me too
  • 2 replies
  • Idea
Photo of Luis del MOlino
XTVR RX gain cahnges with preamp (6500)
When using XTVR in my 6500 with a 2 meters converter, I experience the following changes. -10 dB position Noisefloor Pan -105 dBm Smet...
  • 2 me toos
  • 4 replies
  • Question
  • Answered