Conversations

Photo of W2ECK
Flex 6000 & MMTTY Decode Setup ??
Relatively new owner of a 6600 and user of SSDR. Have yet to attempt RTTY, so just tried to play a bit in OKDXRTTY contest. Have watched ...
  • 1 me too
  • 6 replies
  • Question
Photo of K8AC
Useful 15 pin connector for Flex accessory port
When I came up empty searching my junk box for a 15 pin connector for the accessory socket on my 6500, I ran across this connector online...
  • 2 me toos
  • 8 replies
  • Idea
Photo of K8AC
Flex community forum and Firefox
I have been unable to post items to the community forum using the Firefox browser.  If I switch to Msoft Edge, all is well.  I'm currentl...
  • 1 me too
  • 4 replies
  • Problem
Photo of Kent Olsen
WSJT-X DAX audio settings
Just reading the user guide for WSJT-X 2.0. It says: "Audio input and output devices configured for sample rate 48000 Hz, 16 bits". Does ...
  • 1 me too
  • 4 replies
  • Question
Photo of K8AC
CW Latency on 6500 with current software
Recently acquired a 6500 and was curious about the latency involved in receive and transmit with the current software, and factors that m...
  • 1 me too
  • 1 reply
  • Question
Photo of W2ECK
CW SPEED & N1MM
Issue is with 6600. When running SSDR alone I am able to control cw speed with slider in CW transmit control panel. If I send with a padd...
  • 1 me too
  • 2 replies
  • Question
Photo of K8AC
How to clear RIT on Maestro
Using Maestro 2.4.9.  I know how to turn on the RIT and how to get VFO-B knob to be the adjustment for the RIT frequency.  But, how do we...
  • 1 me too
  • 2 replies
  • Question
Photo of K8AC
how to tell if 6500 pen installed
I recently acquired a Flex 6500 from a private individual and believe that I am the third owner of the unit.  How can I find out if the t...
  • 1 me too
  • 6 replies
  • Problem
Photo of K1UO - Larry
Maestro owners what QSK delay do you use for semi-breakin?
Maestro owners.  If you operate semi-breakin cw and not QSK...what value delay do you use in the Maestro Delay setting (push in the cw ...
  • 1 me too
  • 4 replies
  • Question
Photo of Joe N3HEE
QSK CW Behavior
I have a 6600M running v 2.39. I am hearing a relay no matter what combo of antennas are selected.  The QSK icon is always on no matter w...
  • 2 me toos
  • 4 replies
  • Question
Photo of K8AC
6500, Maestro, CW Skimmer V2
New 6500 user, with Maestro, 2.4.9.  Trying to get CW Skimmer V2 working properly.  Have read all the posts here on the subject.  The b...
  • 1 me too
  • 2 replies
  • Question