Conversations

Conversations 1 - 20 of 89
Photo of Keith Schlottman
Splatter TX on 6500
Looking for ideas about what could be causing such a bad transmit signal?  I got a complaint from another ham that I was splattering wh...
  • 2 me toos
  • 17 replies
  • Problem
  • Solved
Photo of Greg
Antenna persistence
I notice sometimes when I close down SSDR and restart it (usually the next day) the antenna selection is not the same as when it closed. ...
  • 1 me too
  • 6 replies
  • Problem
Photo of Greg
reset kills profiles
Resetting the radio's database during power on also erases any saved profiles and saved CWX messages. Profiles and messages should not ...
  • 1 me too
  • 4 replies
  • Problem
  • Not a Problem
Photo of Bill-W9OL
can't transmit split
I've operated rtty split quite a few time previously but right now...I'm doing something wrong I was down on 12 meter rtty. Saw a station...
  • 1 me too
  • 9 replies
  • Problem
  • Solved
Photo of Greg
Noise floor issues again
Started having the noise floor issues again today.  On 20M with preamp off my NF is usually around -110 to -115 dB.  I was on 6M on one s...
  • 1 me too
  • 2 replies
  • Problem
  • In Progress
Photo of Greg
QSK?
What happened to QSK.  I have delay set to zero but I hear lots of audio popping while sending..not just the rx noise.  Happens with zero...
  • 2 me toos
  • 10 replies
  • Problem
  • Acknowledged
Photo of Greg
AGC threshold persistence
Is anyone else having an issue with AGC-T persistence?  This should be by band.  But anytime I turn the radio on it seems like AGC-T is b...
  • 4 me toos
  • 3 replies
  • Problem
  • Acknowledged
Photo of Greg
6700 Timeout
Today when I turned on the radio it got stuck in calibration mode then displayed TIMEOUT.  Did this twice.  Pulling the power then reconn...
  • 1 me too
  • 2 replies
  • Problem
  • In Progress
Photo of WQ5C - Mike
clicking relay?
I've noticed on several occasions that a relay clicks in & out on a regular basis while the radio is not in use. Most recently, the radi...
  • 1 me too
  • 7 replies
  • Problem
  • Solved
Photo of Greg
Monitoring DAX audio
This is not really a question rather an observation. I know right now monitoring (MON) the DAX tx audio is not available.  But.... Duri...
  • 1 me too
  • 2 replies
  • Problem
  • Acknowledged
Photo of Greg
SmartCat and Win8
Frustration at its finest.  As usual I am unable to install SmartCat on my Win8 system.  Went fine on the Win7 computer.  I have tried ab...
  • 1 me too
  • 24 replies
  • Problem
Photo of Greg
DAX IQ CONNECTIONS
I suffer from the high noise floor problem which pretty much makes things useless.  To correct I have to shut down SSDR and reboot the ra...
  • 2 me toos
  • 5 replies
  • Problem
  • Solved