Conversations

Conversations 1 - 20 of 78
Photo of Gary NC3Z
BSOD on DAX start
For the past few months I have been getting a BSOD (due to portcls.sys) when I start DAX about 1 out of 5 times. I run DAX predominately ...
  • 3 me toos
  • 8 replies
  • Problem
  • In Progress
Photo of Jim
Newbie question
Com ports question......... I’m running a Flex 6400. I have log4om set up and running fine. I want log4om to run anytime the Flex is run...
  • 1 me too
  • 2 replies
  • Question
Photo of Mark Smith - KB5KYX
CESSB
I'm running a 2 tone test on my CESSB waveform, and once the compression meter gets over ~6db (there is no true scale on this meter so it...
  • 2 me toos
  • 3 replies
  • Question
Photo of Don
Dax Rx gain
Why does my DAX Rx gain not work when i first cut the 6400 on until i click on it and move the slider? I am running v2.5.1 and did not ha...
  • 1 me too
  • 6 replies
  • Question
  • Acknowledged
Photo of Gary NC3Z
Fan failure 6600M
Well my fan has gone bad and started causing my 6600M to shut down on it's own and flash the power light red. I can find the exact repla...
  • 1 me too
  • 3 replies
  • Problem
Photo of Tom W3FRG
Start up 6600M
I have seen this fault occur a few times on start up and thought I'd ask if anyone else has experienced it before I report it as a fault....
  • 1 me too
  • 5 replies
  • Question